Retractable Awnings - Previous
page
ROOF MOUNT BRACKET INSTALLATION
These triangular shaped brackets allow
the awning to be mounted higher when there
is a sloped or flat shingle type roof surface
available. If the roof is a barrel or concrete
tile roof, the tiles (where the brackets
are installed) will need to be removed and
replaced after the Sunsurrender awning is
installed. See table below for the number
of awning angle roof brackets needed. BudgetAwnings.com
used an adjustable awning roof bracket so no matter
what angle the roof is, we have you "covered".
In addition to the roof mount brackets,
a roof mount will require wall brackets
if no retractable awning hood is ordered and will require universal
mount brackets if a bullnose awning hood is ordered.
SOFFIT/OVERHANG/EAVE AWNING INSTALLATION
Universal mount brackets are used to mount
the retractable awnings and patio covers under and onto an existing overhang
(soffit/eave). See table below for the number
of awning brackets required.
FASCIA MOUNT AWNING INSTALLATION
The fascia must be strong enough to receive
and hold the complete retractable awning weight and
the pressure it exerts when fully open.
The fascia mount will require wall brackets
if no awning hood is ordered and will require ceiling
mount brackets if a bullnose hood is ordered.
** CLICK HERE FOR AWNINGS BRACKET SIZES
AND SCHEMATIC
Unit
Width |
Number
of Awning Mounting Brackets |
Number
of Arms |
12 foot |
2 |
2 |
16 foot |
3 |
2 |
18 foot |
4 |
2 |
20 foot |
5 |
2 |
A complete set of instructions is sent
with all our Sunsurrender awnings.
Should you need further assistance in measuring,
we are an email or phone call away. Email
is responded to within 24 hours or less.
Retractable Awnings - Previous
page
|